SME MS99-184 A "Gato" Algorithm For The Setup Planning Of Prismatic Parts standard by Society of Manufacturing Engineers, 11/01/1999 Hong-Chao Zhang ; Enhao Lin
SME MS99-185 Autonomous Measurement Of Physical Model Shape For Reverse Engineering standard by Society of Manufacturing Engineers, 11/01/1999 Hideki Aoyama ; Yuu Suzuki
SME MS99-183 Automatic Scanning Process Planning Using A Stripe Sensor standard by Society of Manufacturing Engineers, 11/01/1999 Fernando Funtowicz ; Eyal Zussman
SME MS99-182 Non-Linear Methods For Conicity Tolerance Verification standard by Society of Manufacturing Engineers, 11/01/1999 Sung Hun Chung ; Shivakumar Raman
SME MR99-169 Improvement Of Workpiece Quality Of Ceramic Engine Valves By Kinematic Simulation Of The Valve Grinding Operation standard by Society of Manufacturing Engineers, 11/01/1999 Udo Zitt ; Oliver Braun ; Gunter Warnecke
SME MR99-167 The Effect Of Tool Edge Geometry On Workpiece Sub-Surface Deformation And Through-Thickness Residual Stresses For Hard-Turning Of Aisi 52100 Steel standard by Society of Manufacturing Engineers, 11/01/1999 Jeffrey D. Thiele ; Shreyes N. Melkote
SME MR99-168 Rounding And Lobe Formation During Superfinishing standard by Society of Manufacturing Engineers, 11/01/1999 Biju Varghese ; Stephen Malkin
SME MR99-166 Influence Of Material Microstructure On Tool Performance In High Speed Machining standard by Society of Manufacturing Engineers, 11/01/1999 Jochen Boehner ; Mihaela Dumitrescu ; Mohamed A. Elbestawi ; Tahany I. El-Wardany ; Lienjing Chen
SME MR99-164 Three-Dimensional Modeling Of Gas Metal Arc Welding Process standard by Society of Manufacturing Engineers, 11/01/1999 Yuh-Jin Chao ; Xinhai Qi
SME MR99-165 On-Line Expulsion Detection And Estimation For Resistance Spot Welding standard by Society of Manufacturing Engineers, 11/01/1999 Wei Li ; S. Jack Hu ; Jun Ni
SME MR99-163 Analysis Of No. 50 Taper Joint Stiffness Under Axial And Radial Loading standard by Society of Manufacturing Engineers, 11/01/1999 David M. Shamine ; Yung C. Shin
SME MR99-162 Analysis And Optimization Of Drill Cross-Sectional Geometry standard by Society of Manufacturing Engineers, 11/01/1999 Y. Richard Chen ; Jun Ni