No products
View larger
ASTM C471M-17a
M00021066
New product
ASTM C471M-17a Standard Test Methods for Chemical Analysis of Gypsum and Gypsum Products (Metric)
standard by ASTM International, 10/01/2017
In stock
More info
Full Description
1.1These test methods cover the chemical analysis of gypsum and gypsum panel products, including gypsum ready-mixed plaster, gypsum wood-fibered plaster, and gypsum concrete.
1.2The test methods appear in the following order:
| Sections | ||
| Preparation of Sample | 4 | |
| Complete Procedure | 5 - 16 | |
| Alternative Procedure for Analysis of Free Water in | 17 | |
| Gypsum Using a Moisture Balance | ||
| Alternative Procedure for Analysis of Combined Water in | 18 | |
| Gypsum Using a Moisture Balance | ||
| Alternative Procedure for Analysis for Calcium Sulfate by | 19 | |
| Ammonium Acetate Method | ||
| Alternative Procedure for Analysis for Sodium Chloride by | 20 | |
| the Coulometric Method | ||
| Determination of Sand in Set Plaster | 21 | |
| Wood-Fiber Content in Wood-Fiber Gypsum Plaster | 22 | |
| Optional Procedure for Analysis for Sodium by the Atomic | 23 | |
| Absorption Method | ||
| Optional Procedure for Analysis for Sodium by Flame | 24 | |
| Photometry | ||
| Determination of Orthorhombic Cyclooctasulfur (S8) in | 25 | |
| Ggypsum Panel Products-General Provisions | ||
| Determination of Orthorhombic Cyclooctasulfur (S8) in | 26 | |
| Gypsum Panel Products by Gas Chromatograph | ||
| Equipped with a Mass Spectrometer (GS/MS) | ||
| Determination of Orthorhombic Cyclooctasulfur (S8) in | 27 | |
| Gypsum Panel Products by Gas Chromatograph | ||
| Equipped with an Electron Capture Detector (GC/ECD) | ||
| Determination of Orthorhombic Cyclooctasulfur (S8) in | 28 | |
| Gypsum Panel Products by High-performance Liquid | ||
| Chromatograph Equipped with and Ultraviolet Detector | ||
| (HPLC/UV) |
1.3The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4The values stated in SI units are to be regarded as the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.