Full Description

1.1This test method covers the on-line and in-line determination of dissolved ozone (DO₃) in low conductivity water in the range from 0.001 mg/L to 5.0 mg/L DO₃ and conductivity 100 S/cm, typical of pharmaceutical and microelectronics pure waters. DO₃ is detected by correlating the response of a membrane-covered electrochemical sensor to the dissolved ozone concentration.

1.2This test method provides a more convenient means for continuous measurement than the colorimetric methods typically used for grab sample measurements.

1.3This test method has the advantage of high sensitivity as well as durability in the process environment and has few interferences.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.