Full Description

1.1''This practice covers definitions and procedures for measuring flatness characteristics of uncoated steel sheet and nonmetallic and metallic-coated steel sheet. The methods described are designed and intended to be used in mill situations and environments.

1.2''The sheet shall conform to all the requirements of the appropriate specifications as follows: Specifications A568/A568M or A924/A924M.

1.3''Quantitative limits are not addressed and are established in the general requirements, or individual product specifications, or both; or when applicable, as agreed to between supplier and user.

1.4''Units'''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.