Full Description

1.1This specification covers silver-coated copper braid and ribbon flat wire intended for electronic application (Explanatory Note 1).

1.2Two classes of silver-coated braid and ribbon flat copper wire are covered as follows:

1.2.1Class A-Annealed temper.

1.2.2Class H-Hard-drawn.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1Exceptions-The SI values for density, resistivity, and volume are to be regarded as standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.