M00000102
New product
ISO/IEC 7811-1 4th Edition, September 1, 2014 Identification Cards - Recording Technique - Part 1: Embossing
In stock
Warning: Last items in stock!
Availability date: 07/13/2021
Description / Abstract:
This part of ISO/IEC 7811 is one ofa seriesof
International standards describing the parameters for
identification cards as defined in the definitions clause and the
use of such cards for international interchange.
This part of ISO/IEC 7811 specifies requirements for embossed
characters on identification cards. The embossed characters are
intended for transfer of data either by use of imprinters or by
visual or machine reading. It takes into consideration both human
and machine aspects and states minimum requirements.
It is the purpose of this International standardsto
provide criteria to which cards shall perform. No consideration is
given within these International Standards to the amount of use, if
any, experienced by the card prior to test. Failure to conform to
specified criteria should be negotiated between the involved
parties.
ISO/IEC 10373-1 specifies the test procedures used to check
cards against the parameters specified in this part of ISO/IEC
7811.
NOTE 1 Numeric values in the SI and/or Imperial measurement
system in this part of ISO/IEC 7811 might have been rounded off and
therefore are consistent with, but not exactly equal to, each
other. Either system can be used, but the two is not intended to be
intermixed or reconverted. The original design was made using the
Imperial measurement system.
Note 2 TIM (Tactile Identifier Mark) defined by ISO/IEC 7811-9
can be located in the name and address area of this part of ISO/IEC
7811. The layout of embossed characters in this area is not
intended to interfere with TIM.